Analytical laboratory

Independent testing of peptides and other pharmaceutical products.

SG Laboratory examines the sample as received and reports what the analysis shows — identity, purity, content and related quality attributes — on a signed Certificate of Analysis.

Close-up of red-capped vials in a liquid chromatography autosampler, ready for injection.

Fig. 1 Autosampler vials at the start of a chromatographic run. Laboratory imagery for illustration; not a client sample.

The work

How a sample is handled

Four steps, from the package that arrives to the report that leaves. The full process, including scientific review and supporting raw data, is described on the process page.

01

Receipt and custody

Each shipment is logged as it arrives. The sample is identified, inspected and given a laboratory number that follows it through the work.

02

Analysis

The requested tests are performed using established techniques such as HPLC with UV detection and LC-MS. Methods are chosen to answer the questions you have asked.

03

Scientific review

A second review checks the data, the calculations and the draft wording before a report is approved.

04

Certificate of Analysis

You receive a signed report for the sample that was tested. Where agreed, the report can include raw data such as chromatograms.

Results apply only to the sample as received. Read the testing process.

Tests

What we can report

The panel is agreed for each sample. Not every test is performed on every submission. The names below are the questions most often asked for peptides; other pharmaceutical products have a related quality-control menu.

LC-MS

Identity

Is the mass of the main component consistent with the peptide or substance you have named?

HPLC with UV detection

Purity

What share of the peak area is the main component, and what related substances are visible under the method used?

Content

Net peptide content

How much peptide is present in the vial or sample as received — not only how pure the main peak appears?

Also available, as agreed: endotoxin (LAL), sterility (USP <71>), residual solvents, counter-ion, water (Karl Fischer), vial-to-vial consistency, and testing of other pharmaceutical products. Full testing menu

Example — not a test result

A report you can read through

The Certificate of Analysis states what was tested, by which techniques, and what was found. An example document is provided so you can see the layout. It is clearly marked as an example and is not a measurement of any product.

LIRAVEXIN catalog

A model report for every catalog item

A model testing report and a declared ingredient list have been prepared for each item in the LIRAVEXIN research catalog (www.liravexin.com). They show how those documents would be laid out for that catalog number. They are examples only. They are not test results, and they do not mean that SG Laboratory has already analysed these lots.

Where an official shop photograph of the vial exists, it appears on the model report. Each report also carries a QR code that will open that item’s ingredient list once the site is published. Bacteriostatic water and a small number of other non-peptide accessories are grouped separately in the library.

Enquiry

If you wish to discuss testing a sample

Leave a message on the contact page. The laboratory is at Holzhauser Straße 234, 13509 Berlin. Licences and direct telephone or email details will be published once they are confirmed.